To Next PageTo Next Page
Need help?Do you have a question about the Cembre HT45 and is the answer not in the manual?
Suitable for installing electrical compression connectors for conductors up to 150 mm².
Specifies the tool's crimping force of 50 kN.
Details the tool's length and width when handles are closed and open.
Provides the tool's weight without dies.
Lists recommended hydraulic oils for the tool.
Notes the tool has a max pressure valve and manometer availability.
Steps for preparing the tool, including die insertion and latching.
How to operate the handle to close dies and build pressure.
Procedure for operating the handle until dies meet and pressure is heard.
Using the release lever to retract the ram and open dies.
Steps after work completion to release pressure and fit the handle holder.
Importance of cleaning dust, sand, and dirt from the tool daily.
Guidelines for storing and transporting the tool in its plastic case.
Information on head rotation for operation and a warning.
Detailed steps to remove air bubbles from the hydraulic circuit.
Instructions for checking and topping up the oil level in the reservoir.
General| Brand | Cembre |
|---|---|
| Model | HT45 |
| Category | Crimp tool |
| Language | English |
