Why does my CEN-TECH 2000 watt continuous/4000 watt surge power Inverter shut off during use?
The CEN-TECH Inverter might shut off during use due to an excessive load at the output. Reduce the load to less than the rated power. Alternatively, the internal temperature may be too high. In this case, let the Inverter cool down for at least 30 minutes, ensuring the fan is not blocked and that the Inverter has sufficient ventilation.
What to do if CEN-TECH 2000 watt continuous/4000 watt surge power has no output voltage?
If your CEN-TECH Inverter has no output voltage, check the following: * Ensure cords are properly connected and secured. * Inspect the battery bank fuse and replace if needed. * Have a qualified technician check and replace internal fuses, as opening the housing yourself is not recommended. * Recharge or replace the battery if the input voltage is low. * Clean and tighten any loose or corroded connections. * Remove the charging source and verify the correct battery is being used and connected properly if the input voltage is high.
Why my CEN-TECH Inverter could not drive load?
If the CEN-TECH Inverter cannot drive the load, it might be because the load power is too large. Try lowering the load level. The AWG of the wire might be too low, so use appropriately-sized wire connections. Also, the start power of an appliance can be up to twice the rated power, so reduce the load or change appliances.
To Next Page
General
