Why does my CEN-TECH 60635 Inverter shut off during use?
If your CEN-TECH Inverter shuts off during use, it could be due to an excessive load. Try reducing the load to ensure it's less than the inverter's rated power. Another reason might be that the internal temperature is too high. In that case, let the inverter cool down for at least 30 minutes, ensure the fan isn't blocked, and that the inverter has sufficient ventilation.
What to do if my CEN-TECH 60635 Inverter has no output voltage?
If your CEN-TECH Inverter has no output voltage, begin by checking and securing all connections. Then, inspect the battery bank fuse and replace it if necessary. Also, low input voltage can cause this issue, so recharge or replace the battery. Another potential cause is a loose or corroded connection; clean and tighten any such connections. Finally, high input voltage may be the problem; remove the charging source and verify that the correct battery is being used and connected properly.
Why CEN-TECH Inverter could not drive load?
If your CEN-TECH Inverter could not drive load, this may be because the load power is too large. Try lowering the load level. Another reason may be that the AWG of the wire is too low, use appropriately-sized wire connections. Also, the start power of a device can be up to twice the rated power, reduce load, or change devices.
General| Input Voltage | 12V DC |
|---|---|
| Output Voltage | 120V AC |
| Output Frequency | 60 Hz |
| Waveform | Modified Sine Wave |
| Efficiency | 90% |
| USB Output | 5V DC, 2.1A |
| Cooling | Fan |
| Protections | Overload, Short Circuit |
To Next Page
