What to do if CEN-TECH 40963 Tools have no flash?
If your CEN-TECH Tools have no flash, it might be due to several reasons. First, ensure the switch is in the “ON” position. If it is, check the battery clips to make sure they are connected correctly. If the clips are connected backward, reverse the battery clip connections. Finally, a poor connection of clips can also cause this issue; clean the battery post and reconnect.
What to do if CEN-TECH 40963 Tools have no flash but the double check indicator is “ON”?
If the double check indicator is “ON” but there's no flash in your CEN-TECH Tools, consider these possibilities: 1. The Spark Plug Clamp might be flipped backward. Ensure the arrow on the clamp points to the #1 plug. 2. There could be a weak ignition or spark plug. Try connecting to other plugs or spark plug wires and repair the gap. 3. A faulty lamp could also be the cause. Replace the faulty lamp.
Why does CEN-TECH 40963 Tools light flash intermittently?
The intermittent flashing of the CEN-TECH Tools light could be due to the Timing Light Spark Plug Clamp wire lying on, or near to, the other spark plug wires. To resolve this, route the Spark Plug Clamp wire away from the other spark plug wires.
General safety rules to prevent injury, fire, and electric shock.
Safety rules specific to the product, including label maintenance, pacemakers, and lead warnings.
Illustrates and describes the connection procedure for the timing light.
To Next Page
General