SKU 42396/95652 For technical questions, please call 1-800-444-3353. Page 4
14. Check for damaged parts. Before using any tool, any part that appears
damaged should be carefully checked to determine that it will operate
properly and perform its intended function. Check for alignment and
binding of moving parts; any broken parts or mounting xtures; and any
other condition that may affect proper operation. Any part that is damaged
should be properly repaired or replaced by a qualied technician. Do not
use the tool if any switch does not operate properly.
15. Replacement parts and accessories. When servicing, use only identical
replacement parts. Use of any other parts will void the warranty. Only
use accessories intended for use with this tool. Approved accessories
are available from Harbor Freight Tools.
16. Do not operate tool if under the inuence of alcohol or drugs. Read
warning labels on prescriptions to determine if your judgment or reexes
are impaired while taking drugs. If there is any doubt, do not operate the
tool.
17. Due to the danger inherent in such work, we strongly recommend
that only a licensed electrician work on high-voltage or other
potentially dangerous circuits.
18. This product contains or produces chemicals, including lead, known
to the State of California to cause cancer and birth defects (or other
reproductive harm).
(California Health & Safety Code § 25249.5, et seq.)
19. When using the Insulation Tester (not included), carefully follow
all operating instructions and safety precautions outlined in the
documentation provided with it.
Note: Performance of this tool may vary depending on battery condition.
Warning: The warnings, cautions, and instructions discussed in this instruction
manual cannot cover all possible conditions and situations that may
occur. It must be understood by the operator that common sense
and caution are factors which cannot be built into this product, but
must be supplied by the operator.
Unpacking
When unpacking, make sure the following parts are included: Digital
Clamp Multimeter, black and red Test Leads, hand strap, 9V battery, and
carrying case. If any parts are missing or broken, please call Harbor Freight
Tools at the number on the cover of this manual.
Brought to You by Augusta Flint
To Next Page
Loading...
Need help?
General
