Page 8SKU 47257 For technical questions, please call 1-800-444-3353.
Replacing The Battery
Figure 3
Battery Cover
1. Remove the Battery Cover by sliding
the cover in the direction shown in
Figure 3 above, then tilt the cover up
and off of the unit.
Remove the existing Battery and 2.
replace with an identical Battery as
listedinthe“Specications”charton
page 3 of this manual.
Replace the Battery Cover.3.
NOTE: Dispose of the used Battery in ac-
cordance with all local ordinances.
Cleaning And Maintenance
BEFORE EACH USE, inspect the 1.
general condition of the tool. Check
for any condition that may affect its
safe operation.
After use, wipe with soft, clean cloth 2.
and store inside, away from extreme
hot, or cold and where children do not
have access.
The LCD display and Jaw faces 3.
should be wiped periodically with a
clean, dry, lint-free cloth.
Lubricate the body of the Caliper with 4.
a few drops of clock oil.
Keep Battery Compartment clean, dry 5.
and free of corrosion.
Keep this Caliper dry at all times to 6.
prevent destroying the electronics.
To Next Page
Loading...
Need help?
General
