Page 11For technical questions, please call 1-888-866-5797.Item 59458
SAFETYOPERATIONMAINTENANCE SETUP
DC Voltage Measurement
Measure DC conductors
carrying up to 600 VDC.
WARNING! TO PREVENT SERIOUS
INJURY: Use caution when working
near voltages above 30 VAC rms, 42
VAC peak, or 60 VDC. Voltages this
high present a risk of electric shock.
1. Plug black test lead into COM Jack.
Plug red test lead into INPUT Jack.
2. Turn Rotary Switch to the
position to choose DC voltage.
3. Carefully touch exposed
conductors with tips of probes.
4. Read measured voltage on the Display.
5. When testing is complete, turn
Rotary Switch to OFF, remove
Test Leads and store with Meter.
Note: If voltage is too high,
Display will read OL.
Continuity Measurement
Test continuity between two
points of a circuit.
CAUTION! To prevent electric shock, turn
off all power and fully discharge capacitors
on the circuit under test before measuring.
1. Plug black test lead into COM Jack.
Plug red test lead into INPUT Jack.
2. Turn Rotary Switch to the position.
3. Press MODE until is displayed.
4. Connect the test leads across
the circuit to be measured.
5. Read measured resistance on the
Display. If measured resistance is less
than 50Ω Meter will beep; if the circuit
is open, the display will indicate “OL”.
6. When testing is complete, turn
Rotary Switch to OFF, remove
Test Leads and store with Meter.
To Next Page
Loading...
