Refrigerant Leak Detector
Warm-Up Time: Approximately 45 seconds
Operating Temperature & Humidity:
0 ~40 °C, < 80% RH
Storage Temperature & Humidity:
-10 ~60 °C, < 70% RH
Altitude: < 2000M (6500’)
4. OPERATION GUIDE
(1) The refrigerant leak detector unit is not equipped
with anti-explosive designs and measures. Do not use
this unit in the environment with the burnable gases.
(2) There are some environmental conditions that
might cause error reading:
▪ Pollutant places.
▪ Large temperature variation.
▪ Places with high wind velocity.
▪ Organic solvent, adhesive vapor, fuel gas and
vesicant will cause abnormal response from the
sensor. Try to avoid the environment involved with
this substance.
▪ Places fill with too much to Freon Gas.
To Next Page
Loading...