SKU 66984 For technical questions, please call 1-800-444-3353. Page 10
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Inspect tool before use, looking
for damaged, loose, and
missing parts. If any problems
are found, do not use tool until
repaired.
Tool Set Up
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION: Turn off the tool,
detach the air supply, safely
discharge any residual air
pressure in the tool, and
release the throttle and/or turn
the switch to its off position
before performing any
inspection, maintenance, or
cleaning procedures.
TO PREVENT SERIOUS
INJURY: Do not adjust or
tamper with any control or
component in a way not
specically explained within
manual. Improper adjustment
can result in tool failure or
other serious hazards.
Work Piece and Work Area Set Up
1. Designate a work area that is clean
and well-lit. The work area must not
allow access by children or pets to
prevent injury and distraction.
2. Route air hose along a safe route
to reach work area without creat-
ing a tripping hazard or exposing air
hose to possible damage. Also avoid
sharp bends and do not place items
on hose during use.
3. The air hose must be long enough
to reach the work area with enough
extra length to allow free movement
while working.
4. There must not be hazardous objects
(such as utility lines) nearby that will
present a hazard while working.
General Operating Instructions
1. WARNING! Use only 3/4” Drive
Impact type sockets (not supplied).
2. If an automatic oiler is not used, add
a few drops of Pneumatic Tool Oil
to the airline connection before use.
Add a few drops more after each
hour of continual use.
3. Push and snap socket (not included)
onto Anvil (8). See Assembly
Diagram on page 12.
4. This Wrench can be used in
either Forward or Reverse
direction. To operate in Forward,
turn the Regulator Knob (33)
counterclockwise or to the right.
NOTE: There are three torque
settings for the Forward direction.
5. For Reverse, turn the Regulator Knob
to clockwise or to the left. NOTE:
There are three torque settings for
the Reverse direction.
6. To tighten, place the socket over the
hex nut you wish to tighten.
To Next Page
