Central Pneumatic 68027 - Page 9

Page 9For technical questions, please call 1-800-444-3353.SKU 68027
User-Maintenance Instructions
Procedures not specically explained
in this manual must be performed
only by a qualied technician.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL
OPERATION, BEFORE ANY MAINTENANCE OR
REPAIRS ARE DONE:
• Wear ANSI-approved safety goggles
with side shields. Other people in the
work area must also wear ANSI-approved
impact safety goggles with side shields.
• Release the pressure on the Nail Guide.
• Detach the air supply.
• Attempt to re the Tool against a piece of scrap
wood to ensure that it is disconnected.
• Remove any object from the
Nail Guide before service.
TO PREVENT SERIOUS INJURY
FROM TOOL FAILURE:
Do not use damaged equipment.
If abnormal noise, vibration, or leaking air is detected,
have the problem corrected before further use.
TO PREVENT EXPLOSION: Lubricate only
with specied lubricants. Lubricate the air
inlet using only pneumatic tool oil.
Lubricate the internal mechanism using
only white lithium grease. Other lubricants may
damage the mechanism and may be highly
ammable, causing an explosion.
Note: These procedures are in addition to the
regular checks and maintenance explained as part
of the regular operation of the air-operated tool.
Daily - Air Supply Maintenance:
Every day, perform maintenance on the air supply
according to the component manufacturers’
instructions. The lubricator’s oil level needs to be
maintained and the moisture lter must be regularly
drained. Performing routine maintenance on
the air supply will allow the tool to operate more
safely and will also reduce wear on the tool.