Central Pneumatic 68029 - Loading the Tool

Page 11For technical questions, please call 1‑800‑444‑3353.SKU 68029
Loading the Tool
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL OPERATION,
BEFORE LOADING:
• Wear ANSI‑approved safety
goggles with side shields. Other
people in the work area must also
wear ANSI-approved impact safety
goggles with side shields.
• Release the trigger.
• Detach the air supply.
• Attempt to re the Tool into a
piece of scrap wood to ensure
that it is incapable of ring any
fasteners.
1. Rotate Trigger Safety Lock inward to
prevent accidental ring.
2. Only use the proper size and type of
staple with this tool.
3. Depress the Magazine Release to
open Magazine. Open the Magazine
completely.
4. Turn the Stapler upside down. Place a
full clip of staples inside the Magazine
so the pointed ends of the staples are
directed away from the tool.
5. Keep ngers clear while sliding the
Magazine closed until it clicks shut.
6. Rotate Exhaust Deector to redirect
exhaust air away from you.
General Operating Instructions
1. Test the Tool before each use.
2. If an automatic oiler is not used, add a
few drops of Pneumatic Tool Oil to the
airline connection before use. Add a few
drops more after each hour of continual
use.
3. CAUTION! Place the Drive Guide
against the surface you wish to staple.
Be sure to keep your hands, ngers and
other body parts away from the Nozzle.
4. Depress the Trigger to activate the
Stapler.
5. If the tool requires more force to
accomplish the task, verify that the
tool receives sufcient, unobstructed
airow (CFM) and increase the pressure
(PSI) output of the regulator up to the
maximum air pressure rating of this tool.
CAUTION! TO PREVENT TOOL AND
ACCESSORY FAILURE, RESULTING
IN INJURY: Do not exceed the tool’s
maximum air pressure rating of
120 PSI. If the tool still does not have
sufcient force at maximum pressure
and sufcient airow, then a larger tool
may be required.
6. After use, to prevent accidents:
a. Release the Trigger.
b. Detach the air supply.
c. Attempt to re the Tool into a piece
of scrap wood to ensure that it is
disconnected and is incapable of
ring any fasteners.
d. Release the Trigger again.
e. Clean external surfaces with clean,
dry cloth.
f. Store indoors and out of reach of
children and unauthorized people.