Page 10 H&(%$*4.8"4,7%G'*#$"&8#I%/7*,#*%4,77%JKLLLKLMMKNOPO1 Item 95810
NOTICE
Clean the Spray Gun IMMEDIATELY after use.
Delayed or inadequate cleaning will permanently clog the Spray Gun.
D=H6BC QR6S=B?Q> @=?>B6>=>;6D6BTR
OPERATING INSTRUCTIONS
S*,9%$.*%6>B?S6%?@RQSB=>B%D=H6BC%?>HQS@=B?Q>%#*4$"&8%,$%$.*%+*3"88"83%&2%$."#%
5,8',7%"847'9"83%,77%$*_$%'89*(%#'+.*,9"83#%$.*(*"8%+*2&(*%#*$%'/%&(%'#*%&2%$."#%
/(&9'4$1
?8#/*4$%$&&7%+*2&(*%'#*I%7&&Z"83%2&(%9,5,3*9I%7&&#*I%,89%5"##"83%/,($#1%%
?2%,8E%/(&+7*5#%,(*%2&'89I%9&%8&$%'#*%$&&7%'8$"7%(*/,"(*91
U&(Z/"*4*%,89%U&(Z%=(*,%D*$%T/
1. Designate a work area that is clean
and well-lit. The work area must not
allow access by children or pets to
prevent distraction and injury.
2. Route the air hose along a safe
path to reach the work area without
creating a tripping hazard or exposing
the air hose to possible damage.
The air hose must be long enough to reach
the work area with enough extra length
to allow free movement while working.
3. Before spraying, mask nearby
objects not being sprayed and lay
cloths (not included) on the floors.
>&^^7*
b'89*(%
;,/c
H"83*(%
<*[*(
=9\'#$5*8$%
D4(*)
="(%?87*$
Y,(
H"3'(*%;-%%;&5/&8*8$#%,89%;&8$(&7#
R,"8$%R(*/,(,$"&8%,89%H"77"83
BQ%RS6!6>B%D6S?QTD%?>YTSC-%%A&%8&$%,9\'#$%&(%$,5/*(%)"$.%,8E%
4&8$(&7%&(%4&5/&8*8$%"8%,%),E%8&$%#/*4"2"4,77E%*_/7,"8*9%)"$."8%$."#%
5,8',71%%?5/(&/*(%,9\'#$5*8$%4,8%(*#'7$%"8%$&&7%2,"7'(*%&(%&$.*(%#*("&'#%.,^,(9#1
>&$*- Proper paint mixture is essential.
Follow the manufacturer’s directions.
Most paints will spray easily if
they are thinned properly.
1. Thin the paint according to manufacturer’s
directions and mix thoroughly.
2. Carefully strain the paint through
a paint strainer or a piece of cheesecloth.
3. Fill the Jar to 3/4 full. Close the Jar.
4. Hold the Housing lightly in your hand and
push the tapered fitting on the lid of the
Jar into the base of the Housing. It is held
in place with friction and is not threaded.
5. Start the air compressor and set
the regulator to needed pressure.
A&%8&$%*_4**9%5,_"5'5%,"(%/(*##'(*1
6. Test the consistency by spraying
on a piece of scrap material.
If it still appears too thick, add a very
small amount of thinner (not included)
and mix thoroughly. Use the proper
thinner for the type of paint.
Thin CAUTIOUSLY. Proceed slowly,
adding minimal amounts at a time. %
AQ%>QB%*_4**9%$.*%5,8'2,4$'(*(]#%
$."88"83%(*4&55*89,$"&8#1
To Next Page
Loading...