DE ENFRPL ES
11. Application
17
The
KLOUD
maxi
is suitable for whole-body applications,
whereby, like the
KLOUD
mini
, it can also be ideally used for local
applications when folded.
Tips for your optimized
KLOUD
application:
• Be sure to consume a glass of natural water before and
after use, but do not consume coee or tea before use.
• Do not consume tobacco after using
KLOUD
.
• Make yourself comfortable: Take a comfortable position
in comfortable clothes.
• Ensure the right environment: choose a place with a
comfortable temperature without any stress or distraction,
and use pleasant relaxation music if possible.
1.) Switch on the desired applicator with the power
button. The blue power LED lights ashes.
2.) Wait until the OK LED lights up.
3.) Select the desired program using the program
selection button (P1-P5 by using the keyboard
or others by using the Centropix operating app).
4.) Press the start button to start the selected
program. The programs duration is normally
15 minutes. While a program is running, the
corresponding program number LED ashes.
5.) After the program has nished, the program
LED stops ashing and lights up permanently
again when another program is selected. An
acoustic signal sounds at the end of the program.
«DO NOT DISTURB MODE»
To switch o the LEDs and the acoustic signal during use, i.e. to activate the «do not disturb mode», please press the two buttons
«Select» and «Play» . In a dark environment the lighting can be reduced to one LED («ON») (this cannot be switched o).
By pressing any key you exit the «do not disturb mode» and the LEDs will be displayed again.
11.1. Full-body Application
18
The general full-body application is carried out by default with
the KLOUD
maxi application module with an average
intensity of 100 μT. When the applicator is folded three times,
the maximum average intensity is 180 - 200 μT. For comparison:
The natural earth magnetic eld strength is approx. 35 - 70 μT
depending on the latitude.
The eld distribution extends slightly beyond the applicator
surface. It is therefore of little importance whether head or feet extend
beyond the ends of the applicator during usage.
Also, it does not matter whether the top or bottom of the
applicator is used since the signal is generated identically on
both sides of the coil.
The arrangement of the coil elements is symmetrical. Therefore,
the applicator can be placed, e.g. if you want to place it in a bed,
with the control element (foam element) at the head end as well
as at the foot end.
People with limited physical movement can be «covered» with
the KLOUD
maxi both in a sitting and lying position.
This way you can enjoy the application on the sofa, bed, etc.
comfortably and conveniently.
We recommend two Full body applications daily (one in the
morning one in the evening).
However, do not use more than one KLOUD applicator at
the same time.
To Next Page
Loading...