IVA-1
Section IVA - OPERATING INSTRUCTIONS
WHEEL LIFT
4A.1 For reasons of safety, it is important that the Owner/Operator(s) of
the CENTURY EB-4 / 6500 Wheel Lift System be thoroughly familiar
with its controls, components and load requirements before
attempting any operation.
4A.2 PREPARING TO LOAD VEHICLE
(a) Line Wheel Lift up with center of disabled vehicle to be towed.
See Figure 4A.1.
FIGURE 4A.1
NOTE
LEAVE SUFFICIENT SPACE BETWEEN REAR OF WRECKER
AND VEHICLE TO BE TOWED SO THAT WHEEL LIFT MAY BE
LOWERED TO TOWING POSITION WITHOUT STRIKING
VEHICLE.
(b) Reduce truck’s engine to an idle, and apply parking brake.
Depress clutch, place transmission in neutral and engage PTO.
NEVER DRIVE TRUCK ON STREET WITH PTO ENGAGED,
THIS CAN CAUSE PUMP FAILURE DUE TO OVER-SPEED
AND OVERHEATING.
To Next Page