SmaRT HH-x10
U089.1.1-SmaRT_HH-x10
2.0 Remote Control and Base Unit Communication
2.1 Associate HH-xH10 Remote Control to Base Unit
An HH-x10 remote control unit must establish a communications link with a base unit before it
can be used for control. An HH-x10 remote (as part of a system) is associated with the system
base unit before leaving Cervis, Inc. But, it is possible to associate an HH-x10 in the field either
to address a communication problem or to add or replace a remote control unit. The procedure
to establish the link is called “Association”.
In situations where it is necessary to establish or re-establish remote control-to-base unit
communications, use the following steps:
HH-9H10/2H10 Models:
1. Stand near the base unit with the remote control OFF and power removed from
the base unit.
2. Push and hold the B1 and ON buttons. All six LEDs light solid.
3. Observe the LEDs. When only the TX LED begins to blink, power up the base
unit while continuing to hold B1 and ON.
4. When all six LEDs light solid, release both buttons.
HH-9X10 Models:
1. Stand near the base unit with the remote control OFF and power removed from
the base unit.
2. Push and hold the B1 and ON buttons for approximately two seconds. The A1,
A2, and TX LEDs light. Release the B1 and ON buttons.
3. Press and hold button B1. Turn base unit power on. Release button B1 when
base unit powers up.
The remote control and base unit are connected when both the TX and RX LEDs on both
devices start blinking simultaneously as messages pass between them. The SmaRT system is
ready for use.
Figure 3. Associate an HH-x10 Remote Control to a Base Unit
To Next Page
Loading...