TROUBLESHOOTING
SYMPTOMS
Basssounds distorted
CAUSES SOLUTIONS
Subwoofer amplifier is at maximum output Lowersubwoofervolumeor receiverlevelcontrol
Receiver tone controls are set too high Set bassflat;use tone controls sparingly
Distortion with volume control nearminimum Defective receiveror preamplifier, or shorted Repair defectivereceiver,preamplifier or replace
speaker wires speakerwires
Distortion on music peaks or sound effects Dynamic soundtrack (e.g., explosions) Turn down volume control to lower over£1
range; use a more powerfialreceiver/amplifier
Buzz, hum, or crackle when connecting wires Connecting wires with power on causes tramient Connect wires only when system power is off
signal spikes
50160 cyclehum when systemis on Residentialgrounding problem Use a three-to-two prong AC adaptor (available
at your audio dealer or localelectronic supply).
No sound after listening at high levels Amplifier's thermal protection has been Lowersubwoofer volume and allowamplifier to
temporarily activated cool down; sound should resume automatically
Volume control is at maximum, yet sound is low Both channels are not being driven Use an RCA "y" adapter[o drive both channels
SPECIFICATIONS: HT-S SERIES SPECIFICATIONS: LW SERIES
HT-S10A LW-10/10X
F_QUENO/RESFONSE: 30 to 150 Hz F_EQUENO/RESPONSE: 32 Hz to 180 Hz
A_puF[ra Po'm_ Otm,i_: 100Waas (RMS) _uHr_ PowL_OLrrP_: 100 Wat,s (RMS)
c.o_2_.............. c2_n£"."°__t"Z92"9ogAO_2_50_EL_28__dB_2_"_.....
PotaarrY SWffCH: 0° m 180"(userseLectabLe)
St_SONICFILTE_ 18 dB per octavebelow 30 Hz
VOLTAGe: 115 Vac
DtMF_I$1ONS(H XW x D): 1T' x15" x 15"/ 432 can• 38.1cm x 38.1 cm
Po_r'r SWITCH: 0° or 180° (t_er sHeo_ble)
.........................................
s_E"2cF'J___........ 18'iB_y"= _°w3!___L.....................
VOLT/*_E: 115Vac (LW-10), 115/230 Vac (LW-10X)
DIMF_ZSlOi'lS(H XW XD): 18.5" x 12"x 18.75" / 47canx 30.5 cm x40 cm
o._^____w?,_Em-...... _E__(z_5_.o_....................... _y____5.q__y__,5__-........ 85*_(23.0_.............................................
FINISH; Black woodgralnvinyl FINISH: Black woodgrainvinyl
HT-S12A LW-12/12X
F_QUENCYR_PONSF_ 28 m 150 Hz FF,£qUE_ P,_OI_S_: 30 Hz _o 150 Hz
A_FI_. POW_ OU'I_sr: 150 Wa_ (RMS) _FI_ Po'm.a O_: 150Warn (RMS)
D_t_. D_sl¢;n: 12" high _iclmcy ,_,eofer/diexas__¢odnum flame DRIVERD_SmN: 12" high ei_ciene/weof_ldieost aluminumframe
C_OSSOW_.: Confiauomly variableflora 40 to 150 Hi @ 18 dBlocrave Ceosso'€_: Contin_i_sly variablefrom 40 -150 Hz @18dB/octav:
POL_'_ Swrrol: 0°oe 1800(l_e_wi:oable)
SUBSONICFILTE_ 18dB pe_o_taw bdow 28 Hz
VOLT^G_ 113Vac
DIM_e_SlONS(H XW XD): 19" x 17"x 17" 1483 _ x43.2 _m x432. o_
U_pAO_D WO_Wr: 60 _b(27.3 k0
F*_rSH: Bl,_k wo_.-..i, _.orl
pO_l_r_ SWITOt: 0_ or 180" (users_able)
SUBSONICFILTT2.: 18dB per octavebelow 30 Hz
VOLTAGE: 115Vac (LW-12), 115/230 Vac (LW-12X)
DI_a',ZSIO_S(H x W x D): 19.5" x 14"x 17.3" / 49.5 cmx 35.6 cmx 44 nB
UNe^C_[_ WEm_: 60 Ib(27.3 kg)
FINISH: Bhck v,oodgr,ln vin_l
HT-S15A LW-15/15X
FREQUENCYRESPONSE: 25 to 150 Hz Fp_qUENC_IL_eo_s_ 27 Hz to 150Hz
AMmFIERPOWEaOL_PUT: 200 Watts (RMS) A_pu_ Pow_. O_: 200Wa_ (RMS)
DRrVERDESIGN: 15" high dF_Aenc/_ferl_lie_st duminum flame De.lv_ DESIGN: 15"h_h *:_deBq, w_of_/ditcas_ aluminum frame
Crossov_.: Condmmusly _aiable from40 to 150 Hz @18dBIoctave Cgossov_: Continuously variablefrom40 - 150 Hz @18dB/oc_ave
POLARITYSWiTOA: 0_or 180_ (m_"sd_.'oable} PoLg_.ffYS_O4: 0"ot 180"(m_zs_le)
SU_ONICFILTE_ 18dB per octavebdow 25 Hz SlaVONICFILTEg: 18 dBper ochre below25 Hz
VOLTAGE: 115Vac VOLTAGE; 115Vac (LW-I8). 1151230Va_ (LW-I 5X)
DIM_ASlONS(H XW XD): 23.5" x 18.75" x 18.75" / 59.7 _ x 47.6 _ra x47.6 cm Dit,_t_sloNs (H XW x D): 21"x IT x 18" 1533 o_ax 43.2 _ x45.7 can
UNpt_ED WElkin': 72 Ib (32.8 Do) UNPt_g_ WEtGFrr: 72 Ib (32.8 kg)
FINISH: Bleakv,_d_n vinyl FINISH: Blackwoo_r_ _iny[
Geawln-V_ismmtanfl,/mMngtomlm_a tbehlgbe__ sland=ads.Asan:s_ltolrtheseeffom,raoclificath_roayh_madefrmntimetotimeto_tistiag_a_ _t _r _.
6 Spedfica_m andappearar.emaydiff=fromthoseIlatedor#aowain thismaaual.
To Previous Page
Loading...
Need help?
Frequency Response
