15
www.seagullmodels.com
Linkage.
.
9) Move the throttle stick to the closed position
and move the carburetor to closed. Use a 2.5mm
hex wrench to tighten the screw that secures
the throttle pushrod wire. Make sure to use
threadlock on the screw so it does not vibrate
loose.
LANDING GEAR INSTALLATION:
A. NOSE GEAR:
1) Locate the items necessary to attach the
nose landing gear that are included with your
model.
3
1
2
4
5
4
1
2
2
3
Screw.
To Next Page
