Cessna Cessna, 337 Skymaster User Manual

1
www.seagullmodels.com
Specifications:
Wing span -------------------------76.8in (195.0cm)
Wing area --------------806.0sq.in (52.0sq dm)
Weight -----------------------------9.9-11.0lbs(4.5-5.0kg)
Length ---------------------------57.1in (145.0cm)
Engine -------------0.36 - 0.46 cu.in -----2-stroke.
0.52 - 0.72cu.in -----4-stroke.
Radio ----------------- 6 channels with 10 servos.
Electric conversion :optional..
ASSEMBLY MANUAL
MS:146
“Graphics and specifications may change without notice”.
“Cessna, 337 Skymaster, emblems, logos, and body designs
are trademarks of Textron Innovations Inc. and are used
under license by Seagull Models Manufacturing and Trading
Company LTD.
”
68-6412-32462

Cessna Cessna, 337 Skymaster Specifications

General

Brand	Cessna
Model	Cessna, 337 Skymaster
Category	Toy
Language	English

Summary

Introduction and Specifications

Model Specifications

Details the physical dimensions and specifications of the Cessna 337 Skymaster model.

Initial Setup: Safety and Kit Contents

Overview of the model, essential safety warnings, and kit components.

Airframe Assembly - Control Surfaces

Hinging Control Surfaces

Step-by-step guide for hinging flaps, ailerons, elevators, and rudder using C/A glue.

Control Horn Installation

Instructions for installing control horns for flaps, ailerons, elevators, and rudder.

Engine, Fuel, and Landing Gear Systems

Engine Mount and Fuel System Setup

Engine mount installation, fuel tank stopper assembly, and fuel tank preparation.

Landing Gear and Servo Installation

Installing servos, throttle servo arm, landing gear, and flight control switch.

Exterior Components and Electric Power

Cowling and Spinner Fitting

Preparing and fitting the cowl, and installing the spinner assembly.

Electric Power Conversion Guide

Recommendations and steps for converting the model to electric power.

Tail Assembly and Control Linkages

Pushrod Horns and Stabilizers

Installing pushrod horns and mounting vertical/horizontal stabilizers.

Control Linkages Assembly

Installation of elevator and rudder pushrod horns and associated linkages.

Final Assembly and Flight Readiness

Pilot, Battery, Receiver, and Wing Attachment

Installing the pilot, battery, receiver, and attaching the wing to the fuselage.

Balancing and Flight Preparation

Critical steps for model balance, control throws, and preflight checks.