23
www.seagullmodels.com
The propeller should not touch any part
of the spinner cone. If it does, use a
sharp modeling knife and carefully trim away
the spinner cone where the propeller comes
in contact with it.
INSTALLING THE SPINNER BEFORE.
Install the spinner backplate, propeller and
spinner cone.
INSTALLING THE SPINNER AFTER.
Install the spinner backplate, propeller and
spinner cone.
The propeller should not touch any part
of the spinner cone. If it does, use a
sharp modeling knife and carefully trim away
the spinner cone where the propeller comes
in contact with it.
Speed control.
INSTALLING THE AILERON.
To Next Page
