Operator’s Manual Addendum
Notices and Compliance Declarations
AD-2
POWER CORD SET REQUIREMENTS
The power cord set supplied with your
instrument meets the requirements of the
country where you purchased the
instrument.
If you use the instrument in another
country, you must use a power cord set
that meets the requirements of that
country.
This equipment is designed for connection to a grounded (earthed) outlet. The
grounding type plug is an important safety feature. To reduce the risk of electrical
shock or damage to the instrument, do not disable this feature.
To reduce the risk of fire hazard and electrical shock, do not expose the unit to rain or
humidity. To reduce the risk of electrical shock, do not open the cabinet. All maintenance
is to be performed by an Authorized CETAC Service Provider.
Protection provided by the equipment may be impaired if the equipment is used in a
manner not specified by the manufacturer.
CLEANING INSTRUCTIONS
To clean the exterior surfaces of the instrument, complete the following steps:
1
Shut down and unplug the instrument.
2
Wipe the instrument exterior surfaces
only using a towel dampened with a
lab-grade cleaning agent.
3
Repeat step 2, using a towel dampened
with clear water.
4
Dry the instrument exterior using a dry
towel.
Do not allow any liquid to enter the instrument cabinet, or come into contact with
any electrical components. The instrument must be thoroughly dry before you
reconnect power, or turn the instrument on.
COOLING FAN OBSTRUCTION
The instrument cooling fan(s) shall remain unobstructed at all times. Do not operate the
instrument if the cooling fan(s) are blocked or obstructed in any manner.
ENVIRONMENTAL
Operating Temperature: 10° to 30°C
Relative Humidity 0% to 95%
Altitude 0 to 10000 Ft
WARNING
CAUTION
WARNING
To Next Page
Loading...
