CETAC ASX-520 User Manual

Complete Guide for Upgrading ASX-520
and ASX-520HS Autosamplers with an
EXR-8

CETAC ASX-520 Specifications

General

Brand	CETAC
Model	ASX-520
Category	Laboratory Equipment
Language	English

Summary

Guide for Upgrading the Firmware on the ASX-520 and ASX-520HS Autosamplers with an EXR-8

Software and Firmware Acquisition

Details on obtaining and upgrading software and firmware for the autosampler.

Accessing Autosampler Board

Instructions for accessing internal components of the autosampler.

Establish Communications

Steps to establish serial communication with the autosampler.

Rabbit Utility Setup

Configuration steps for the Rabbit Field Utility software.

Autosampler Programming Mode

Steps to configure the autosampler's programming mode via jumpers.

Firmware Upload Process

Procedure for loading the firmware file using the utility.

Return to Normal Configuration

Steps to return the autosampler to its normal operating configuration.

Firmware Upgrade Verification

Commands to verify the successful firmware upgrade.

Guide to Operating a CETAC Autosampler Using HyperTerminal

HyperTerminal Operation Steps

Instructions for connecting and controlling the autosampler using HyperTerminal.

Guide to Installing the EXR-8 with a CETAC Autosampler

Cart Assembly

Instructions for assembling the EXR-8 cart.

Head Assembly Removal

Steps to detach the autosampler's head assembly from its base.

Mounting Head Assembly on Extended Rack

Procedure for attaching the autosampler head assembly to the Extended Rack.

Chain Assembly Installation

Instructions for installing the chain assembly kit.

Connecting Head Assembly to Rack

Details on connecting the autosampler head assembly to the Extended Rack.

Connecting Autosampler to Host Computer

Steps for connecting the autosampler to the host computer.

Extended Rack Alignment

Procedures for aligning the Extended Rack using software.