CETAC ASX-520 - Installing the Extended Rack; Guide to Operating a CETAC Autosampler Using Hyperterminal; Guide to Installing the EXR-8 with a CETAC Autosampler

Installing the Extended Rack
The EXR-8 Extended Rack is designed for easy installation. Installation consists of four parts:
Upgrading the firmware on the CETAC autosampler, removing the autosampler head from its
base, assembling the Extended Rack, and connecting it to the host analytical instrument.
This document contains three guides to help in the installation of the EXR-8:
Guide for Upgrading the Firmware on the ASX-520 and ASX-520HS Autosamplers with an
EXR-8
1. Software and Firmware Upgrade
2. Accessing the Board inside the Autosampler
3. Establish Communications
4. Setup of Rabbit Utility
5. Autosampler Programming Configuration
6. Autosampler Normal Configuration
7. Verification of Firmware Upgrade
Guide to Operating a CETAC Autosampler Using HyperTerminal
1. Steps for operating the autosampler with HyperTerminal
Guide to Installing the EXR-8 with a CETAC Autosampler
1. Assemble the Cart.
2. Remove the head assembly from the base of the autosampler.
3. Mount the head assembly (autosampler) onto the Extended Rack.
4. Connect the autosampler to the Host Computer
5. Align the Extended Rack.