MAINTENANCE & LUBRICATION
122
Cooling system
Coolant level inspection
1. Place the Vehicle on a level surface.
2. Check the coolant level in the coolant reservoir when the
engine is cold as the coolant level will vary with engine
temperature.
3. If the coolant is at or below the lower limit mark, remove the
access cover and the reservoir cap
1
, add coolant to the
upper limit mark, install the reservoir cap, and then install
the access cover.
NOTE
The coolant should be between the upper and lower limit marks.
Lowest capacity of coolant reservoir: 0.23 L
CAUTION
Hard water or salt water is harmful to the engine. You may use
soft water if you can not get distilled water.
Attention
If water is added,have your dealer check the antifreeze content
of the coolant as soon as possible. The radiator fan operation
is completely automatic. It is switched on or off according to the
coolant temperature in the radiator
To Next Page
Loading...
Need help?
General
