150
MAINTENANCE
4. Remove the engine oil drain bolt from the bottom of the
crankcase and drain the oil.
5. Place a new sealing washer on the drain bolt, then assemble
and tighten the drain bolt to 22 ft-lb. (30 N•m).Remove the oil
lter cover fasteners
4
and cover
5
from the crankcase.
6. Remove the oil lter cartridge
6
from the crankcase housing.
7. Install a new oil lter cartridge in the crankcase housing.
8. Inspect and verify the cover O-ring
7
is okay to reuse, and
then install it into the groove of the crankcase housing correctly.
9. Install the oil lter cover and fasteners. Tighten the fasteners to
7.3 ft-lb. (10 N•m).
10. Add the specified amount of recommended engine oil, and
then reinstall the engine oil dipstick and hand-tighten it.
NOTE:
Oil change with oil filter: 2.64 qt. (2.5 L) Maintain the oil level
between the upper and lower indicators.
11. Start the engine and allow it to run for 2-3 minutes. While the
engine is running, check for oil leaks. If an oil leak is found,
turn the engine o immediately and check for the cause.
12. Turn the engine off. Recheck the oil level and correct it if
necessary.
4
5
7
6
To Next Page
Loading...
