CF MOTO ZFORCE 800EX - Page 158

154
MAINTENANCE
Front gear case oil change
4. Place the vehicle on a level surface.
5. Place an oil pan under the gear case to collect the used oil.
6. Remove the oil drain bolt
2
at the bottom of the gear case and
drain the oil.
7. Install the oil drain bolt and tighten it to 18.4 ft-lb. (25 N•m).
8. Remove the oil ller bolt. Add su󰀩cient oil to raise the level up
to the brim of the hole.
9. Install the oil ller bolt and tighten it to 18.4 ft-lb. (25 N•m).
NOTE:
Approximate front gear case oil capacity: 11.2 oz. (330mL)
2