Challenge JO - Challenge Drill-Ease Lubricant Stick; Challenge Drilling Blocks; Challenge Fiber Blocks; Challenge Power Sharpener

11.0 Accessories for Challenge Paper Drilling Machine
26
Teflon Coated Hollow Drill Bits
Diameter x Drill Capacity Cat. No.
1/8” x 5/8” (3.2 x 16mm) TCD-2-3
5/32” x 11/8” (4 x 29mm) TCD-52
3/16” x 15/8” (4.8 x 41mm) TCD-3
7/32” x 2” (5.6 x 51mm) TCD-72
¼” x 2” (6.3 x 51mm) TCD-4
17/64” x 2” (6.7 x 51mm) TCD-174
9/32” x 2” (7.1 x 51mm) TCD-92
5/16” x 2” (7.9 x 51mm) TCD-5
11/32” x 2” (8.7 x 51mm) TCD-112
3/8” x 2” (9.5 x 51mm) TCD-6
13/32” x 2” (10.3 x 51mm) TCD-132
7/16” x 2” (11.1 x 51mm) TCD-7
½” x 2” (12.7 x 51mm) TCD-8
11.2 Challenge Drill-Ease Lubricant Stick
Cat. No. 4688
This lubricating stick provides a dry stainless lubricant which has many uses throughout the printing
plant. It is specially recommended for use on hollow drills for easier drilling, particularly when drilling
clay-coated stock. It eliminates binding and excessive heating of the drill. Will not discolor the stock.
CARE MUST ALWAYS BE TAKEN WHEN USING STICK AND HANDLING DRILLS.
11.3 Challenge Drilling Blocks
Cat. No. A-4682
These Challenge 11/2” (38 mm) wood drilling blocks are for round hole drilling operations. Sold in
packages of 12.
11.4 Challenge Fiber Blocks
Cat. No. KK-474
These tough, 11/2” (38 mm) fiber cutting blocks are recommended for all cornering and slitting
operations. Sold in packages of 12.
11.5 Challenge Power Sharpener
(115 Volt / 60 HZ only)
Cat. No. A-6450
This power drill sharpener plugs into any standard 115 volt, 60 cycle, AC outlet. Handles Challenge
and other taper shank drills.