Challenge XSS40E - Operating the Lawnmower; Step 2: Starting the Engine (Continued)

10
Customer Helpline 01904 727503
www.gardenservicecentre.co.uk
Operating the Lawnmower
Step 2 - Starting the Engine (continued)
Engine stop
Engine start
2a Press the primer bulb (A) 3-5 times.
When starting a cold engine, press down the primer fully 3~5 times.
Pressing the primer button too many times could cause the engine to ood. (too much
petrol in cylinder causing hard start)
NOTE! When starting a warm engine, the primer does not need to be used. If the engine stops
due to a lack of petrol, rell and press down the primer 3~5 times.
2b Start/Stop Bar Activation
Pull the Start/Stop bar towards you.
2c Pull cord handle
With right hand, slowly but rmly pull the starter handle and rope from the pull cord guide until
you feel resistance, then pull briskly. If the engine fails to start after three pulls, repeat the start
process. When the engine starts, return the starter rope to the pull cord guide gently.
3. To stop, release stop/start bar
2a
2c
2b
A