EasyManua.ls Logo

Challenger MT225 - Page 9

Default Icon
31 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
A-8 - GENERAL INFORMATION
79019435B
Hydraulics
Main hydraulic system
Pump Gear pump (Open center)
Output – maximum 4.8 gpm /18.0 liters/min
Pressure - relief valve setting 140 kgf/cm
3
/ 1990 psi
Rear linkage type Three-point hitch
Control Operated by single ‘position’ control lever
Lift capacity 1058 lbs./480 kg measured at link ends
Steering system type Hydrostatic
Pump Gear/Flow divider
Output–maximum 5.5 liters/min./1.5 gpm
Pressure–relief valve setting 105 kfg/cm
3
Electrical system
System voltage 12 volt - negative (-) ground
Battery 36hA (5hr)/433 cca
Charging 40 amp alternator with internal regulator
Capacities
Engine crankcase with filter 2.9 qts/2.7 liters
Transmission and differential housing (including
hydraulics) (liters)
STD 14.3 qts / 13.5 liters Hydro 15.9 qts./15.0 liters
Fuel tank 3.6 gal/13.5 liters
Cooling system 5.4 qts/5.1 liters
Front axle - four-wheel drive 2.9 qts/2.7 liters
Maximum axle loading
Front four-wheel drive – both models 1433 lbs/650 kg
Rear axle – both models 1653 lbs/750 kg
Tire size
Front
Agricultural tire 5–12 4PR
Turf tire 20.5 x 8.00-10 4PR
Rear
Agricultural tire 8–16 4PR
Turf tire 29 x 12.00-15 4PR
Find manuals at https://best-manuals.com

Related product manuals