Safety
1-30 639782-1
MAINTENANCE AND SERVICE
FIG. 84: Read and understand maintenance and
safety instructions before performing any maintenance
procedures.
Only trained and qualified personnel should perform
any maintenance procedures or repairs.
Never modify any equipment or add attachments not
approved by AGCO.
PRACTICE CORRECT MAINTENANCE
FIG. 85: Never lubricate, service or adjust any
systems or components while machine is moving.
Never wear a necktie, necklace, scarf or loose clothing
when working near machine tools or moving parts.
Tie long hair behind head and wear a hair net.
Remove all jewelry to prevent electrical shorts or other
personal injury when working with machine tools or
moving parts.
FIG. 86: Stop engine and remove key.
Allow machine to cool.
Keep all parts in good condition and properly installed.
Fix any damaged machine systems or components
immediately.
Replace worn, damaged or broken parts immediately.
Remove any build-up of grease, oil or debris.
Disconnect electrical system before making
adjustments or welding on machine.
CHEMICAL SAFETY
Operator Cabs
FIG. 87: This cab complies the EN 15695-1: 2009 Cat
4 with a filter element complying to EN 15695-2: 2009
Cat 4 which provides protection against dust, aerosols
and vapour. Follow chemical manufacturer’s
instructions.
Protection against hazardous substances (agricultural
chemicals, etc.) is not provided. Personal protective
equipment must be used according to the chemical
manufacturer’s recommendations. A protection against
dust, aerosols and vapour (EN 15695-1: 2009 Cat 4) is
provided under the following conditions:
FIG. 84
FIG. 85
FIG. 86
FIG. 87
To Next Page
Loading...
Need help?
General
