Chamberlain 41A7305-1 - User Manual

1
Smart Control Panel
®
Safety Reversing Sensors
Détecteurs inverseurs de sécurité
Sensores de inversión de seguridad
Yellow LEARN Button
Touche jaune LEARN
Botón "LEARN" (APRENDIZAJE) amarillo
SMART CONTROL PANEL
®
Model 41A7305-1
To prevent possible SERIOUS INJURY or DEATH from
electrocution:
• Be sure power is NOT connected BEFORE installing door
control.
• Connect ONLY to 12 VOLT low voltage wires.
To prevent possible SERIOUS INJURY or DEATH from a closing
garage door:
• Install door control within sight of garage door, out of reach
of children at a minimum height of 5 feet (1.5 m), and away
from ALL moving parts of door.
• NEVER permit children to operate or play with door control
push buttons or remote control transmitters.
• Activate door ONLY when it can be seen clearly, is properly
adjusted, and there are no obstructions to door travel.
• ALWAYS keep garage door in sight until completely closed.
NEVER permit anyone to cross path of closing garage door.
FEATURE OVERVIEW
For use with MyQ
®
Garage Door Openers. The features are adjustable and may be turned off or on as desired. Refer to the Feature Settings section.
A
A
SCREEN
The screen will display the time and temperature until the menu
button is pressed, and then it will display the menu options. If
there is a problem with the garage door opener the screen will
display the Diagnostic Code.
LIGHT BUTTON
Press the LIGHT button to turn the garage door opener lights on or
off. When the lights are turned on they will stay on until the LIGHT
button is pressed again, or until the garage door opener is
activated. Once the garage door opener is activated the lights will
turn off after the specified period of time (the factory setting is
4-1/2 minutes). The LIGHT button will not control the lights when
the door is in motion. The duration of the light timing can be
adjusted by accessing the menu using the navigation buttons.
MOTION SENSOR
The motion sensor will automatically turn on the garage door
opener lights when motion is detected. The lights will come on for
the set period of time, then shut off. The factory setting is on and
set at 4-1/2 minutes.
LOCK
The LOCK feature is designed to prevent activation of the garage
door opener from remote controls while still allowing activation
from the door control and keyless entry. This feature is useful for
added peace of mind when the home is empty (i.e. vacation).
TIMER-TO-CLOSE (TTC)
DO NOT enable TTC if operating a one-piece door. TTC is to be
used ONLY with sectional doors. Factory default is set to off. TTC
can be set to automatically close your garage door from the fully
open position after a specified period of time (1, 5, 10 minute
intervals or a custom setting up to 99 minutes). The garage door
opener will beep and the lights will flash before closing the door.
The screen on the door control can display the status of the TTC.
TTC WILL NOT work if the garage door opener is operating by
battery power or if the safety reversing sensors are misaligned.
This feature is NOT intended to be the primary method of closing
the door. A keyless entry should be installed in the event of an
accidental lock out when using this feature.

Summary

General Safety Warnings

Safety Warnings

Crucial safety instructions to prevent injury or death from electrocution and closing doors.

Feature Overview

Screen Display

Describes the information displayed on the control panel screen and diagnostic codes.

Light Button Operation

Explains how to turn garage door opener lights on/off using the light button.

Motion Sensor Lighting

Details how the motion sensor automatically activates garage door opener lights.

Lock Feature

Functionality to prevent remote activation, enhancing security when the home is empty.

Timer-to-Close (TTC)

Feature to automatically close the garage door after a set time interval.

Installation Guide

Wiring the Door Control

Instructions for connecting wires to the door control unit.

Mounting the Door Control

Steps for physically attaching the door control to the wall.

Wiring to Garage Door Opener

Guidance on connecting the door control wires to the garage door opener.

Operation of Controls

Push Bar and Navigation Buttons

Basic operation using the push bar and navigation buttons for functions.

Lighting Features

How to operate garage door lights manually and via motion sensor.

Timer-to-Close and Lock Functions

Details on using the automatic closing and security lock features.

Battery Backup Status

Information displayed when there's an issue with the battery backup.

Programming and Connectivity

Remote and Keypad Programming

Step-by-step guide to programming remote controls and keyless entry PINs.

Wi-Fi Setup

Instructions for configuring the Wi-Fi connection for the garage door opener.

Menu Navigation and Settings

Navigating Features and Settings Menus

How to access and navigate the Features and Settings menus for customization.

Warranty Information

One Year Limited Warranty

Details the terms and conditions of the product's one-year limited warranty.

Chamberlain 41A7305-1 Specifications

General

Type	Garage Door Opener Control Panel
Model Number	41A7305-1
MPN	41A7305-1
Color	White
Wireless	No
Compatibility	Chamberlain garage door openers
Buttons	3
Weight	4 ounces