Champ CW-898A - Dispensing and Indicator Troubleshooting

PROBLEM SHOOT
ra ray
Hot water is dripping from dispensing
aT oe alee ec se
1. Inlet water pressure is
Se
Check inlet water pressure from pre-
nozzle. too low. filtration system or water supply.
2. The solenoid valve got | Contact service people.
malfunction.
Sparkling water is dripping from 1. The remaining Wait for a few seconds, it will be
dispensing nozzle. sparkling water in stopped.
pipe is flowing due to
CO2
2. The solenoid valve got | Contact service people.
malfunction.
UV indicator light is blinking and 1. UVlampis failure or | Replace a UV lamp or check if the UV
hearing beeps when dispensing no UV lamp is wire is disconnected.
water. connected
2. UV board is failure. Contact service people.
All dispensing buttons are blinking 1. There is leakage Unplug the power cord, then dry
and hearing beeps when press detected inside of water on the internal base or ask for
button. water dispenser. service.
2. The waste water Please drain all water from waste
container is full. water container.
Bubble of sparkling water is 1. The COz and water Please wait more time.
insufficient. doesn’t mixed
properly.
2. CO almostruns out. | Replace CO: cylinder
3. CQ2 output pressure is | Please adjust output pressure to 4 bar
too low. as Suggestion.