201319 - 4500W DUAL FUEL ELECTRIC START INVERTER GENERATOR
OPERATION
28
5. Press and hold the yellow ignition switch on the EZ Start Dial
toward the center of the dial. Release as the engine begins to
start. If the engine fails to start within five seconds, release
the switch and wait at least ten seconds before attempting to
start the engine again. and hold ignition switch on EZ Start
Dial.
CAUTION
If the ignition switch is held down in the “START” position
longer than 5 seconds it could damage the starter.
NOTICE
If the engine is cranked longer than 5 seconds, the engine can
flood and will not start.
Manual Start
Cold Engine Start
6. Move the EZ Start dial to the “CHOKE” position.
7. Slowly pull the starter cord 3-5 times to prime the engine.
8. Turn the EZ Start Dial to the “RUN” position.
9. Pull the recoil cord slowly until resistance is felt and then pull
rapidly.
Warm Engine Start
4. Turn the EZ Start dial to the “RUN” position.
5. Pull the recoil cord slowly until resistance is felt and then pull
rapidly.
To Next Page
Loading...
Need help?
General
