a. To log static on the TKO receiver,
simply set up your TKO receiver on the
pole with a tripod/bipod, or on a tripod
with an adapter
b. Turn on the TKO with the power button
c. Once the receiver says “Tracked”
Double press the Power button.
d. The receiver will beep according to
how often it is collecting data. If it is set
at 1 epoch you will hear a beep every
second, 5 epoch every 5 seconds etc..
NOTE: If you are setting up as a base or rover,
set up as normal then doublet tap the power
button to begin collecting static data
a. Once you have collected the amount of
data you need (OPUS recommends 2
hours) double tap the power again to
stop logging data.
b. You can now turn off your receiver and
return to the office for data transfer.
a. Connect the TKO to your PC through
the com 1 power port using the USB
connection on the “Y” cable provided
with the receiver.
b. Power on the receiver.
To Next Page
General