7.Stopping of the engine
Caution:
Do not stop the engine suddenly since it may causer the temperature to rise abnormally and
shorten the service life of the engine.
(1)Move the speed control lever to low speed position, and run the engine for about 5
minutes with no load.
(2)Set the speed control lever to the “STOP” position, and never stop the engine with the
decompression lever.
(3)Return the fuel cock to “S”(closed)position.
(4)Slowly pull out the recoil handle until pressure is felt, this means the piston is on the
compression stroke where the intake and exhaust valves are closed. This prevents rust from
forming while the engine is not in use.
(5)In electric-start models, set the starter key to the “OFF” position directly.
Preparations for using the engine next time
(1)Replenish the fuel tank with fuel.
(2)Check whether the bolts, nuts of every parts become loose. If become loose and must
tighten.
(3)Remove the dust and dirty on the surface of the cylinder.
To Next Page
Loading...