Need help?Do you have a question about the Chappee 1.45 FF HTE and is the answer not in the manual?
This boiler is designed to heat water at a lower than boiling temperature at atmospheric pressure.
Initial lighting of the boiler must be carried out by a licensed technician. Ensure the following operations are carried out:
To correctly light the burner proceed as follows: 1) provide power supply to the boiler; 2) open the gas cock; 3) follow the directions given below regarding the adjustments to be made at the boiler control panel.
Understanding and clearing fault codes displayed on the boiler.
List of fault codes, their descriptions, and required actions.
Boiler design, system connection, and essential installation precautions.
Guidance on selecting boiler location and connecting pipework.
Procedures and warnings for installing flue and air duct systems.
Electrical safety and connection procedures for the boiler.
Calibration steps for the gas valve for optimal heat output.
Detailed electrical wiring diagram for boiler connections and components.
To Next Page
General