Maintenance and Precautions
Other
1. Do not turn on the LED lights before entering the water to avoid damages.
2. Check if the Thrusters/propellers are getting stuck by seaweed or external matters, rinse the ROV with fresh water and then dry and put
it back in the packing box.
3. Remote control cannot be washed with water, please clean it with towel.
4. The pull ring at the end of the battery can only be used to remove the battery, not to lift the ROV, otherwise it may damage the ROV.
5. Do not place heavy objects on drone or accessories to avoid possible damage.
6. People under the age of 16 should only use this drone under adult supervision.
7. When not in use, please do not expose the drone and accessories under sunlight. Store it in a cool place orin a special box.
8. Chloride or other chemicals can erode Chasing M2. Do not use if the pool is under high chlorine level.
Support
Any questions about our products please contact by support@chasing-innovation.com or leave a message on the Chasing Website
(https://www.chasing.com) chatting window.
You could have the latest user manual by the
http：//www.chasing.com
This content is subject to change without prior notice.
Navigation Safety
1
Battery Protection
2
Open sea
navigation
Relatively clear
water quality, no
dense seaweed
No dense radio
or radar signals
Do not dive
more than
330 ft
330ft
Charging Protection
3
·Only use the Chasing standard adapter.
·Red light means charging.
·Green light means fully charged.
Do not run out
of battery power
Charge when
power is less
than 25%
When not in use,
keep battery power
at 50% - 70%
Working
temperature
-10 °C ~ 60 °C
( -18°F-140°F)
a. Do not touch the propellers of the Thruster
b. Do not unlock the Thruster for more than 30
seconds in the air to avoid overheating
c . After using the ROV in the salt water, please
put it in fresh water for about 1 hour and turn
it on, let the drone run for10 minutes to
discharge the salt, and try out the water after
cleaning with a towel.
Thruster/ Propeller
4
Connector Sockets /
Tether Connectors
5
·Check the Connector socket and tether
pre-dive, keep dry and clean.Salt and
moisture may cause corrosion of the
connector. Be sure to wash the socket
with fresh water if the interface has water
stains, and make the connectors dry
after cleaning.
O-ring
6
· Check whether the O-ring on the tether
connector pre-dive. If it is missed or
damaged, please replace it in time.
To Previous Page
Loading...
