What to do if Chattanooga Group Hydrocollator M-2 water does not get hot?
If the Chattanooga Group Heater is plugged in but the water isn't heating up, there are a few potential causes. First, check if the breaker for the electrical circuit is off and turn it on. If the breaker is on, the thermostat might not be functioning properly and may need replacement. Alternatively, the heating element could be burned out, requiring a replacement.
Explains symbols like CAUTION, WARNING, DANGER used in the manual.
Details symbols and labels used on the Hydrocollator Heating Units.
Provides specifications for SS and SS-2 Hydrocollator Heating Units.
Provides specifications for E-1 and E-2 Hydrocollator Heating Units.
Provides specifications for M-2 and M-4 Hydrocollator Heating Units.
Lists part numbers and descriptions for SS and SS-2 models.
Lists part numbers and descriptions for E-1 and E-2 models.
Lists part numbers and descriptions for M-2 and M-4 models.
Provides guidance on cleaning the Hydrocollator Heating Unit to prevent rust.
Offers advice on how to maintain and replace Hydrocollator HotPacs.
General| Brand | Chattanooga Group |
|---|---|
| Model | Hydrocollator M-2 |
| Category | Heater |
| Language | English |
To Next Page
