What to do if Chattanooga Group Hydrocollator E-1 water does not get hot?
If the Chattanooga Group Heater is plugged in but the water isn't heating up, there are a few potential causes. First, check if the breaker for the electrical circuit is off and turn it on. If the breaker is on, the thermostat might not be functioning properly and may need replacement. Alternatively, the heating element could be burned out, requiring a replacement.
Defines symbols for safety instructions like CAUTION, WARNING, DANGER.
Explains symbols and labels found on the Hydrocollator units.
Explains the function of the white and red indicator lamps on the units.
Illustrates and labels the parts of Hydrocollator units, showing E-2 and E-1 models.
Details specifications for SS, SS-2, E-1, E-2, M-2, and M-4 Hydrocollator models.
Explains how to operate the Hydrocollator Heating Unit and its controls.
Details the capacity of the HotPac rack for different unit models.
Provides part numbers for SS, SS-2, E-1, E-2, M-2, and M-4 Hydrocollator models.
Instructions for cleaning and draining the Hydrocollator Heating Unit.
Provides steps for maintaining the unit's condition and warranty.
Advice on preventing rust and tips for cleaning the unit and its components.
Guidance on how to care for and replace Hydrocollator HotPacs.
General| Brand | Chattanooga Group |
|---|---|
| Model | Hydrocollator E-1 |
| Category | Heater |
| Language | English |
To Next Page
