What to do if Chattanooga Group Heater water does not get hot?
If the Chattanooga Group Heater is plugged in but the water isn't heating up, there are a few potential causes. First, check if the breaker for the electrical circuit is off and turn it on. If the breaker is on, the thermostat might not be functioning properly and may need replacement. Alternatively, the heating element could be burned out, requiring a replacement.
Outlines critical safety warnings for potential serious injury and significant equipment damage.
Lists power supply, frequency, consumption, capacity, temperature, and dimensions for the SS model.
Lists power supply, frequency, consumption, capacity, temperature, and dimensions for the SS-2 model.
Lists power supply, frequency, consumption, capacity, temperature, and dimensions for the E-1 model.
Lists power supply, frequency, consumption, capacity, temperature, and dimensions for the E-2 model.
General| Model | M-4 |
|---|---|
| Power Supply | 120V, 60Hz |
| Material | Stainless Steel |
| Type | Hydrocollator |
| Capacity | 4 Standard Packs |
| Temperature Range | 160°F - 170°F (71°C - 77°C) |
To Next Page
