A
Abigail TorresSep 23, 2025
What to do if Chauvet Pro-D6 has no laser output?
- CClayton DickersonSep 23, 2025
If your Chauvet Switch has no laser output, the bounce mirror motor may have shifted during shipping. Readjust it.
To Next PageTo Next PageWhat to do if Chauvet Pro-D6 has no laser output?
If your Chauvet Switch has no laser output, the bounce mirror motor may have shifted during shipping. Readjust it.
Why is my Chauvet Pro-D6 fixture not responding?
If the Chauvet Switch fixture isn't responding, verify the DMX dip switch settings for correct addressing. Also, check the DMX cables and polarity switch settings.
How to fix loss of signal on Chauvet Pro-D6?
To resolve signal loss with your Chauvet Switch, use only DMX cables and install a terminator. Keep DMX cables separated from power cables or black lights.
What to do if Chauvet Pro-D6 Switch breaker/fuse keeps blowing?
If the breaker or fuse keeps blowing on your Chauvet Switch, check the total load placed on the device.
Why is there no audio movement on my Chauvet Switch fixture?
If your Chauvet Switch fixture is on but not responding to audio, ensure you have selected the correct audio mode on the control switches. If using a ¼” jack, confirm a live audio signal exists and adjust the sound sensitivity knob.
Why is Chauvet Switch chase too slow?
To adjust the speed of the chase on your Chauvet Switch, check the user's manual for speed adjustment instructions.
What to do if Chauvet Pro-D6 Switch remote does not work?
If the remote for your Chauvet Switch isn't working, make sure the connector is firmly connected to the device.
What to do if Chauvet Pro-D6 Switch has no flash?
If your Chauvet Switch has no flash, re-install the bulb, as it may have shifted during shipping.
Why does Chauvet Pro-D6 Switch keep blowing breaker/fuse?
If the breaker or fuse keeps blowing on your Chauvet Switch, check the total load placed on the device.
What to do if Chauvet Pro-D6 Switch light will not come on after power failure?
If your Chauvet Switch light doesn't come on after a power failure, some discharge lamps require a cooling off period. Wait 5 to 10 minutes before powering up the device again, because the electronics in the fixture need this time to restart the lamp.
Details power requirements and connection guidelines for the fixture.
Outlines essential safety precautions for using the fixture.
Explains how to connect multiple fixtures for DMX control.
Describes how to connect the fixture to power sources.
Power| autoswitching | 100V AC or 240V 50/60Hz |
|---|---|
| power output at 110V | 15A (1, 725W) per channel, 20A (2, 300W) max (x2) |
| power output at 230V | 15A (3, 450W per channel, 20A (4, 600W) max (x2) |
| circuit breaker (Line A) | 20A |
| circuit breaker (Line B) | 20A |
Operating Environment| maximum ambient temperature | 104°F (40°C) |
|---|
Weight and Dimensions| length | 19.3 in (490 mm) |
|---|---|
| width | 5.7 in (144 mm) |
| height | 3.9 in (100 mm) |
| weight | 9.7 lbs (4.4 kg) |
