EasyManua.ls Logo

Check Point Smart-1 150 - User Manual

Check Point Smart-1 150
4 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Classification [Protected] P/N:705275 | 1
© 2013 Check Point Software Technologies Ltd. All rights reserved.
For a list of our trademarks, please refer to: http://www.checkpoint.com/copyright.html.
For a list of our Third Party Copyright notices, please refer to: http://www.checkpoint.com/3rd_party_copyright.html.
Installing Smart-1 150 Hard Disk
Drives
705275
Protected
2013
Smart-1 150
Item
Description
1
Hard disk drive #1
2
Hard disk drive #12
Smart-1 150 uses a dedicated LSI Logic RAID controller to perform RAID 10 mirroring and
striping across all of the hard disk drives. The appliance supports RAID configurations with 4, 8,
or 12 hard disk drives.
Adding Hard Drive Storage
Smart-1 150 can contain up to 12 hard drives. This section explains how to add more hard
drive storage to appliances that were purchased with less than 12 hard drives.
Overview
1. Turn off the appliance.
2. Install the additional four or eight hard disk drives.
3. Turn on the appliance.
4. Run the commands to add more RAID arrays to the appliance.
Question and Answer IconNeed help?

Do you have a question about the Check Point Smart-1 150 and is the answer not in the manual?

Summary

Installing Smart-1 150 Hard Disk Drives

Adding Hard Drive Storage

Instructions for adding more hard drive storage to appliances with less than 12 drives.

Overview of Adding Hard Drive Storage

High-level steps to add more hard drive storage to the appliance.

RAID Storage Guidelines

Adding RAID Arrays

Procedure to install and configure new RAID arrays by adding more hard disk drives.

To Add a New RAID Array

Step-by-step instructions for adding a new RAID array to the appliance.

Replacing Hard Disk Drives

Hard Disk Drive Pairs for Replacement

Identifies pairs of hard drives that can be safely replaced simultaneously.

Removing and Installing a Hard Disk Drive

Removing a Hard Disk Drive

Procedure to safely remove a hard disk drive from the appliance.

Installing a Hard Disk Drive

Procedure to insert a replacement hard disk drive and ensure RAID array rebuilding.

Check Point Smart-1 150 Specifications

General IconGeneral
Wi-FiNo
Ethernet LANYes
Cabling technology10/100/1000Base-T(X)
Networking standardsIEEE 802.3, IEEE 802.3ab, IEEE 802.3u
Ethernet LAN data rates10, 100, 1000 Mbit/s
Security algorithms802.1x RADIUS
Serial ports quantity1
USB 2.0 ports quantity2
Connectivity technologyWired
Ethernet LAN (RJ-45) ports4
Operating temperature (T-T)0 - 40 °C
Operating relative humidity (H-H)5 - 95 %
Power supply930 W
Power consumption (typical)399.6 W
Number of power supply units3
Power requirements90 - 264V, 47/63Hz
DisplayLCD
CertificationCE, FCC, RoHS
Rack capacity3U
RAID levels10
HDD capacity1000 GB
Total storage capacity4000 GB
Weight and Dimensions IconWeight and Dimensions
Weight29500 g
Dimensions (WxDxH)632 x 442 x 131 mm

Related product manuals