Chefwave Swap Pot CW-AFPC01 - Error Codes

27
ERROR CODE CAUSE SOLUTION
E1
Temperature sensor
open circuit
Unplug the power
cord and replug after
10 minutes. If the error
code remains, contact
the manufacturer for a
replacement part.
POT
Temperature sensor
short circuit
Unplug the power
cord and replug after
10 minutes. If the error
code remains, contact
the manufacturer for a
replacement part.
The pot is missing or
positioned improperly
Discontinue use and
unplug the appliance.
Properly position the
inner pot.
E3
The temperature is too
high, or the inner pot
does not contain liquid.
Display shows a blinking
“00:XX.”
Unplug the power
cord. Carefully remove
the inner pot from the
base and allow it to
cool down. Add the
appropriate amount of
liquid. Wait 10 minutes
before replugging the
cord. If the error code
remains, contact the
manufacturer for a
replacement part.
E4
A signal switch
malfunction has
occurred
Unplug the power
cord and replug after
10 minutes. If the error
code remains, contact
the manufacturer for a
replacement part.
ERROR CODES