REV. C PN J63143 - 4 -
WARNING: Secure chemicals & metering pumps, making them inaccessible
to children & pets.
WARNING: DO NOT PUMP FLAMMABLE LIQUIDS.
WARNING: To reduce the risk of electrical shock-before maintenance, repair,
or moving always disconnect the power to the pump by unplugging from wall
outlet.
WARNING: Do not tamper with, cut the plug or ground lug off the electrical
cord. Consult a licensed electrician for proper installation.
WARNING: Always wear protective clothing, including gloves and safety eye
protection, when working on or near chemical metering pumps, consult
chemical manufacture for protective equipment recommendations.
WARNING: Always make sure the voltage on the pump data plate matches
the installation voltage before plugging the pump into a wall outlet or hooking
up to an electrical supply. If you are unsure have a licensed electrician
inspect and install your pump.
WARNING: Always depressurize system and drain the chemical prior to
installation or maintenance.
WARNING: Read and fully understand the section on tube replacement.
Failure to do so may lead to serious injury.
WARNING: DO NOT MODIFY PUMP, as this poses a potentially dangerous
situation and voids the warranty.
WARNING: If the injection point is lower than the chemical tank and pump,
install an anti-siphon valve.
WARNING: All pumps are factory tested with water. Remove tubing and
thoroughly dry if the chemical being pumped will react with water (for
example: sulfuric acid).
WARNING: Only finger tighten plastic connections (Do not use a wrench).
WARNING: Consult licensed plumber and electrician before installation to be
sure to conform to local codes.
CAUTION: Inspect tubing regularly for cracking or deterioration and replace
as necessary. (Always wear protective clothing and safety eye protection
when inspecting tubing.)
CAUTION: KEEP FINGERS AWAY FROM ROTATING PARTS.
CAUTION: If the pump is exposed to direct sunlight, use a U.V. resistant
tubing.
CAUTION: Follow directions and warnings provided with the chemical from
the chemical manufacturer. The user is responsible for determining the
chemical compatibility with the chemical feed pump.
CAUTION: Consult with local health officials and qualified water conditioning
specialists when treating potable water
CAUTION: For accurate volume output, the pump must be calibrated under
all operating conditions.
3. Technical Specifications
Refer to the data plate located on the back of the peristaltic pump. Note that the
data plate will be located behind the back splash cover if installed. Please make
note of the Electrical Rating, Feed Rate and Maximum Pressure of the pump.
To Next Page
Loading...