I
15
GB
WHERE TO PLACE THE WIND & SUN SENSOR
SETTING OF SEVERAL MOTORS TO ONE SENSOR
ATTENTION!
The Windtec sensor must be positioned to the side, as close as possible to its awning, and
not above or below the awning coverage area.
One single Windtec sensor can be used to automate a group of motorised awnings. For a
correct function, the coupled awnings must be mounted and exposed to sunlight and wind
in the same way. Do not connect more then 5 motors to one wind sensor.
RIGHT
RIGHT RIGHT
WRONG WRONG
WRONG
To Next Page
Loading...