CHERUBINI WINDTEC - Setting the Wind & Sun Sensor; Associating Sensor to Motor; Deleting the Wind & Sun Sensor; Removing Sensor from Motor

18
GB
SETTING THE WIND & SUN SENSOR
DELETING THE WIND & SUN SENSOR
To associate Windtec sensor to a motor, a remote control must be already memorised on
the motor. The setting sequence is the following:
Tn: already programmed remote control
To delete the Windtec sensor from the motor, must be used a already programmed remote
control. The deleting sequence is the following:
Tn: already programmed remote control
+
A
B
B
TnTn
2 sec
set
TnTn
+
A
B
2 sec
A
set
Button set
1
2
3
4
51
2
3
4
5