A/C System
121
closes and all actuating mechanisms
shut down at the same time and stop
operating.
6. Mode control pushbutton
Use the pushbutton to select one of five
settings (one setting is selected every
press) to control the direction of air
flow:
This setting is designated to introduce
the air and guide it to flow across the
vent of instrument panel;
This setting is used to introduce the air
and guide it to flow across the vent of
instrument panel and the channel near
the floor at the same time;
This setting is used to introduce the air
and guide it to flow across the channel
near the floor;
This setting is used to introduce the air
and guide it to flow across the channel
near the floor and the front defroster at
the same time;
This setting is used to introduce the air
and guide it to flow across the front
defroster.
7.A/C compressor ON/OFF
pushbutton
To start the A/C system, press the A/C
switch. The A/C compressor will
operate automatically in the case of set
mode, unless the outside temperature is
less than 2℃.
8. Defrost pushbutton
Press this pushbutton to enable
the system to forcefully switch
into the DEFROST mode
.
9. / (air volume +/-
pushbutton)
The air volume increases by one
gear every one press of the
pushbutton until up to the 6
th
gear
(max.);
(Face & Foot)
(Foot)
(Foot & Defrost)
(Defrost)
(Face)
To Next Page
Loading...
Need help?
General
