Easy Entry Seat (Extended Cab)
The
right
front bucket or split-bench seat
of
your vehicle
makes it easy
to
get in and out
of
the rear vehicle area.
Tilt the right front seatback completely forward and
the whole seat will slide forward.
Move the right front seatback to its original position
after someone gets into
the
rear seat area. Then move
the seat rearward until it locks.
A
CAUTION:
If’an easy entry right front seat isn’t locked, it
can move. In a sudden stop
or
crash, the person
sitting there could be injured. After you’ve used
it, be sure to push rearward
on
an easy entry seat
to be sure it is locked.
Tilt the seatback completely forward again
to
get out.
Jump
Seat (Extended Cab Models)
Your extended cab
pickup has
a
jump seat
in the rear area.
To
fold the jump seat down,
pull
down
on
the
handle
on
the bottom
of
the seat
until
the
seat is in place, then
move the seatback
to
a vertical position.
To
store the
seat, fold the seatback down on the cushion, then push
,
the entire seat up until it is flush with the trim panels.
Don’t
let
the safety belts be damaged by the hinges or
the latches. Safety belts should be folded and stored
between the seat cushion and seatback.
To Next Page
Loading...
Need help?
General
