2.
Peel the protective
backing from the hook
and loop patch.
3.
Press it firmly to the back of your garage door
opener, as close to the center of the opener as
possible.
over the console door button and press the opener
firmly into place.
4.
Center the garage door opener activation button
5.
The pegs inside the compartment door are used to
make sure the button on the compartment door will
contact the control button on the garage door
opener.
6.
Add
one
peg at a time until the garage door opener
operates with the compartment door closed when
you press the button.
2-41
To Next Page