Chevrolet 2003 S10 Pickup - One-Piece Front Turn Signal Lamps

5. Turn the bulb assembly counterclockwise to remove
it from the headlamp assembly.
6. Put the new bulb into the bulb assembly and
reinstall it in the headlamp assembly by turning
it clockwise until it is tight.
7. Plug in the electrical connector
8. Put the headlamp lens assembly back into the
vehicle.
9. Install the two retaining clips.
10. Close the hood.
One-Piece Front Turn Signal Lamps
1. Remove the headlamp assembly as shown in
"One-Piece Composite Headlamp System"
under Headlamps on page 5-55.
I
2. Twist the bulb socket
counterclockwise to
remove it from
I? : the headlamp
assembly.
_:
3. Pull the bulb straight out to remove it from the
4. Push the new bulb into the socket until it snaps into
5. Put the bulb socket into the lamp assembly and
6. Put the headlamp assembly back into the vehicle.
7. Install the two retaining clips.
8. Close the hood.
socket.
place.
twist it clockwise until it
is tight.
5-57