Before your vehicle was shipped from the factory,
it
was programmed in Mode 1. The mode to which
the vehicle was programmed may have been changed
since it left the factory. To determine the mode to
which your vehicle is programmed or to program your
vehicle to a different mode, do the following:
1.
Follow the instructions for
Entering Programming
Mode
on
page
2-63.
2. Insert your spare key fully into any door key
cylinder and turn it to the unlock position.
This step is necessary to prevent accidental
programming
of
this feature to Mode 2.
Do
not
program this feature to Mode 2 without first reading
Mode
2
entirely. The door key cylinder must
remain in the unlock position during
Steps 2 through
4.
3.
Press the button with the horn symbol on the
remote keyless entry transmitter.
4.
Count the number of chimes you hear. The number
of chimes indicates the vehicle’s current
programmed mode.
(If
you do not wish to change
the current mode, you can either exit the
programming mode by following the instructions
later in this section or program the next feature
available on your vehicle.)
5. Press the panic button to change the current mode.
6.
Press the panic button until you hear the number
of chimes corresponding to the mode selection
you want.
7. Remove your key from the door key cylinder.
The mode you selected is now set.
You
can either exit
the programming mode by following the instructions
next in this section or program the next feature available
on your vehicle.
Exiting Programming
Mode
To exit programming mode, turn the key from
ACCESSORY to OFF and put the BCM PRGRM fuse
back into the instrument panel fuse block.
After programming a feature, you can exit the
programming mode at anytime. Also,
if
your vehicle is
equipped with the content theft-deterrent system,
remember to arm the system before exiting.
2-71
To Next Page
Loading...
Need help?
General
